Delta 36-325C Instruction Manual download pdf (Page 15)

Fig. 26

Fig. 27

Fig. 29Fig. 28

5. Check the alignment of the splitter (C) Fig. 29, to the

saw blade using a straight edge as shown. If alignment

is necessary, loosen nut (B), align splitter (C) and

retighten nut (B).

3. Assemble the blade guard and splitter assembly (C) to

the splitter bracket (A) using the hex head screw, star

washer and flat washer (D) Fig. 27, and wing nut, star

washer and flat washer (E) Fig. 28.

4. NOTE: Make certain the two protrusions, “pins” (F)

Fig. 28, are engaged with the channel of the splitter

assembly (C) before tightening wing nut (E).

ASSEMBLING BLADE

GUARD AND SPLITTER

ASSEMBLY

1. WARNING: WHEN ASSEMBLING THE BLADE

GUARD AND SPLITTER ASSEMBLY, MAKE CERTAIN

THE TOOL IS DISCONNECTED FROM THE POWER

SOURCE.

2. Assemble splitter bracket (A) to the end of the guard

support rod using the two hex nuts and flat washers (B),

as shown in Fig. 26.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

No comments

Delta 36-325C Instruction Manual Page 15