Delta 36-325C Instruction Manual download pdf (Page 19)

Fig. 44

Fig. 45

Fig. 46

Fig. 47

1. Your miter gage is equipped with individually adjust-

able index stops at 90 degrees and 45 degrees right and

left. Adjustment to the index stops can be made by

loosening lock nuts (A) Fig. 44, and tightening or

loosening the three adjusting screws (B) against the stop

link (C).

2. To operate the miter gage, loosen lock handle

(D) Fig. 44, and move the body of the miter gage (E)

to the desired angle. The miter gage body will stop at

90 degrees and 45 degrees both right and left. To rotate

the miter gage body past these points, the stop link (C)

must be flipped out of the way.

MITER GAGE OPERATION

AND ADJUSTMENTS

3. The miter gage is equipped with a special washer (F)

Fig. 45, and a flat head screw (G) which are assembled

to the bottom end of the miter gage bar (H). The special

washer (F) rides in the T-slotted miter gage slot (J) and

prevents the miter gage from falling when it is extended

out beyond the front of the saw table, as shown in Fig.

46.

ADJUSTING TABLE INSERT

The table insert (A) Fig. 47, should be adjusted so it is

flush with the saw table surface. Place a straight edge or

square (B) on the saw table extending over the insert, as

shown. If an adjustment to the insert is necessary,

tighten or loosen the two adjusting screws (C).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

No comments

Delta 36-325C Instruction Manual Page 19