Delta 31-735 Instruction Manual download pdf (Page 14)

BELT SANDER TABLE

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2. Thread a 3/8-16 lock nut (A) Fig. 21, onto a 3/8-

16x3½" stud (B).

NOTE: THREAD LOCK NUT FAR ENOUGH SO THAT

THE NUT (A) FIG. 12 IS FLUSH OR SLIGHTLY BELOW

THE THREADS ON THE STUD.

3. Place a 1-3/16" spring (C) Fig. 21, onto stud (B).

4. Insert sanding ratchet lever (D) Fig. 21, onto stud (B).

5. Thread a 3/8-16 hex nut (E) Fig. 21, onto stud (B).

6. Place a 3/8" flat washer (F) Fig. 21, onto stud (B).

Fig. 21

7. Loosen ratchet lever (H) Fig. 22, and raise the belt

sander so that it is in the horizontal position as shown

and tighten lock knob (H).

Fig. 22

8. Align the sanding table guide (J) Fig. 23, with cutout

(K) Fig. 23, on the side of the sanding belt frame.

Fig. 23

Fig. 24

9. Thread the sanding ratchet lever / stud assembly (L)

Fig. 24, through the sanding table slot (N) Figs. 23 and

24, and into the tapped hole (M) Fig. 23, in the side of

the sanding frame.

NOTE: THREAD THE SANDING TABLE RATCHET

LEVER / STUD ASSEMBLY APPROXIMATELY 1/2"

INTO THE SANDING TABLE FRAME.

10. Use the sanding table ratchet lever to thread the hex

nut (E) Fig 21, against the sanding table, to hold the

sanding table in place.

NOTE: THE RATCHET LEVER (A) FIG. 24 CAN BE

REPOSITIONED BY PULLING OUT ON THE HANDLE

AND REPOSITIONING IT ON THE NUT LOCATED

UNDERNEATH THE HUB OF THE RATCHET LEVER.

THE EDGE OF THE TABLE MUST BE

POSITIONED A MAXIMUM OF 1/16

INCH AWAY FROM THE SANDING BELT

TO AVOID TRAPPING THE WORK OR

FINGERS BETWEEN THE TABLE AND

SANDING BELT.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

No comments

Delta 31-735 Instruction Manual Page 14