Delta 31-735 Instruction Manual download pdf (Page 23)

END SANDING

WITH THE BELT

When sanding the ends of wide workpieces

it is more

convenient to use the sanding belt with the sanding arm

in the vertical position as shown in Fig. 57.

THE EDGE OF THE TABLE MUST BE

POSITIONED A MAXIMUM OF 1/16 INCH AWAY

FROM THE SANDING BELT TO AVOID TRAPPING

THE WORK OR FINGERS BETWEEN THE TABLE AND

SANDING BELT.

Fig. 57

SANDING OUTSIDE CURVES

Outside curves should be sanded on the sanding disc as

shown in Fig. 58.

ALWAYS SAND ON THE LEFT

(DOWNWARD) SIDE OF THE SANDING DISC, AS

SHOWN. SANDING ON THE RIGHT (UPWARD) SIDE

OF THE SANDING DISC COULD CAUSE THE

WORKPIECE TO FLY UP WHICH COULD BE

HAZARDOUS.

THE EDGE OF THE TABLE MUST BE

POSITIONED A MAXIMUM OF 1/16 INCH AWAY

FROM THE SANDING DISC TO AVOID TRAPPING

THE WORK OR FINGERS BETWEEN THE TABLE

AND SANDING DISC.

Fig. 58

END SANDING

WITH THE DISC

When sanding the ends of narr

ow workpieces use the

sanding disc, as shown in Fig. 59. Move the work from

the center to the left side of the sanding disc.

ALWAYS SAND ON THE LEFT (DOWN-

WARD) SIDE OF THE SANDING DISC, AS SHOWN.

SANDING ON THE RIGHT (UPWARD) SIDE OF THE

SANDING DISC COULD CAUSE THE WORKPIECE TO

FLY UP WHICH COULD BE HAZARDOUS.

THE EDGE OF THE TABLE MUST BE

POSITIONED A MAXIMUM OF 1/16 INCH AWAY

FROM THE SANDING DISC TO AVOID TRAPPING

THE WORK OR FINGERS BETWEEN THE TABLE AND

SANDING DISC.

Fig. 59

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Delta 31-735 Instruction Manual Page 23

Comments to this Manuals

Related products and manuals for Power sanders Delta 31-735