25
MAINTENANCE
REPLACING SANDING BELT
1. DISCONNECT MACHINE FROM
POWER SOURCE.
2. Loosen the two lock knobs (A) Fig. 64, and remove
the top cover (B).
Fig. 64
3. Loosen the two lock knobs (C) Fig. 65 enough to
allow the back panel (D) Figs. 64 and 65, to open. NOTE:
The lock knobs (C) cannot be removed.
Fig. 65
4. Release the belt tension by turning the hand lever
(E) Fig. 64. Slide the belt (F) Fig. 66 off of both sanding
drums.
Fig. 66
5. Slide the new sanding belt over both sanding
drums. Ensure that the belt runs in the direction of the
arrow, printed on the inside of the belt.
6. Apply tension to the sanding belt and replace the
top cover removed in STEP 2.
7. Close the back panel (D) Figs. 64 and 65, and
tighten the two lock knobs (C) Fig. 65 that were
loosened in STEP 3.
8. Check the belt tracking before applying power to the
sander.
REPLACING SANDING DISC
See the section “ABRASIVE DISC” in the “ASSEMBLY”
section of this manual.
A
A
B
C
C
D
D
E
F
Comments to this Manuals