Delta 31 Instruction Manual download pdf (Page 21)

MAINTENANCE

DISCONNECT MACHINE FROM POWER

SOURCE.

1. Make sure that the belt sander is in the horizontal

position as shown in Fig. 55.

Fig. 56

Fig. 57

Fig. 55

2. Remove the two screws (A) Fig. 56, on top of the

gear box cover (G) Fig. 55.

3. Remove the two screws, located right below screws

(A) Fig. 56, on the bottom of the gear box cover. Remove

the gear box cover.

4. Remove the screw (D) Fig. 57, on top of the gear

box.

5. Fill the gear box with machine oil and replace screw

(D) Fig. 57.

6. Replace the gear box cover and screws that were

removed in STEPS 2, 3, AND 4.

LUBRICATION

After the machine has been operated for approximately

500 hours, check oil level.

1 2 ... 16 17 18 19 20 21 22 23 24

No comments

Delta 31 Instruction Manual Page 21