Delta 31 Instruction Manual download pdf (Page 22)

REMOVING THE DRUM

DISCONNECT MACHINE FROM POWER

SOURCE.

1. Open the belt sander guards and remove the sanding

belt.

2. Remove nut (A) and washer from the shaft (J) Fig. 59.

Fig. 59

3. Insert the two 1/4-20x1-3/4" socket head screws

through holes (C) and (D) Fig. 60, on the retraction plate

(E).

4. Thread screws (C) and (D) Fig. 60 into the two

tapped holes (F) in the drum.

Fig. 60

Fig. 61

5. Thread a 5/16-18 x 1-1/4" socket head screw (G)

Fig. 61, into the tapped hole (H) in the retraction plate.

6. Turn screw (G) Fig. 61, against shaft (J) Fig. 60. This

will pull the drum off the shaft.

7. To install drum, place the drum on the shaft, replace

the washer and nut that were removed in STEP 2 and

tighten securely.

1 2 ... 17 18 19 20 21 22 23 24

No comments

Delta 31 Instruction Manual Page 22