Delta TS300 Instruction Manual download pdf (Page 10)

ATTACHING THE SAW TO THE STAND

1. Invert the saw table face down on a piece of cardboard

to protect the table surface. Align the four holes in the

saw cabinet with the four holes in the stand.

2. Place a 3/8" flat washer on an M8 x 1.25 x 16mm hex

head screw. Insert the screw through the hole in the

stand and the hole in the saw. Place another 3/8" flat

washer and an M8 x 1.25 hex nut on the screw. Tighten

securely. Repeat this process for the three remaining

holes.

3. Invert the saw table face up (Fig. 6).

4. Push down on the top of the saw so that the legs of the

stand adjust to the surface of the floor.

5. Tighten all of the stand hardware.

INSTALLING THE HANDWHEELS

1. Attach the blade-raising handwheel (A) Fig. 7 to the blade-raising shaft (B). Check to see that the slots (C) in the hub of

the handwheel are engaged with the roll pin (D) on the shaft.

2. Place a flat washer on the end of the shaft. Thread the lock knob (E) Fig. 8 on the shaft.

3. Attach the blade-tilting handwheel (F) Fig. 8 to the blade-tilting shaft in the same manner.

1. Align the three holes in the extension wing (A) Fig. 9 with the three holes in the side of the saw table.

2. Place a 5/16" lockwasher and a 3/8" flat washer on an M8 x 1.25 x 16mm hex head screw. Insert the screw through the

hole in the extension wing and into the tapped hole in the side of the saw table. Hand tighten. Repeat this process for

the two remaining holes in the extension wing and the saw table.

3. Use a straight edge (C) Fig. 10 to ensure that the extension wing (A) is level with the saw table (D).

4. Securely tighten the three screws (B) Fig. 9.

5. Install the other extension wing to the opposite side of the table in the same manner.

Fig. 6

Fig. 7

Fig. 8

Fig. 10

Fig. 9

INSTALLING THE EXTENSION WINGS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

No comments

Delta TS300 Instruction Manual Page 10