Delta TS300 Instruction Manual download pdf (Page 9)

For Saw Stand

1. Top Front and Rear Braces - 19" in length

(2)

2. Bottom Front and Rear Braces - 22-1/2"

in length (2)

3. Stand Legs (4)

4. Feet (4)

5. 3/8" Flat Washer (32)

6. M8x1.25x16mm Carriage Head Screw

(32)

7. M8x1.25 Hex Nut (32)

8. Bottom Side Braces - 20" in length (2)

9. Top Side Braces - 16-1/2" in length (2)

ASSEMBLY

ASSEMBLY TOOLS REQUIRED

ASSEMBLY TIME ESTIMATE

STAND ASSEMBLY

Assemble the stand as shown in Figs. 4 and 5, using the parts shown in Fig. 3. Insert the M8 x 1.25 x 16mm carriage

head screws through the legs and braces, then place the 3/8" flat washers on the screws. Secure with the M8 x 1.25

hex nuts. Install a rubber foot (4) Fig. 5 on each leg (3).

NOTE: Loosely tighten the hardware for further adjustment.

NOTE: The top lips of the two top side braces (9) Fig. 4 fit over the top lips of the front and rear braces (1). The side

braces (9) have holes on top for mounting the saw to the stand.

Fig. 4

Fig. 5

7/8" Open End Wrench (Supplied)

7/8" Box End Wrench (Supplied

10 mm Open-End Wrench

13 mm Open-End Wrench

19 mm Open-End Wrench

Flat-head Screwdriver

The assembly time for this unit is approximately 2 to 3 hours.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

No comments

Delta TS300 Instruction Manual Page 9