Delta TS300 Instruction Manual download pdf (Page 20)

For certain cutting operations such as dadoing and moulding where you are not cutting completely

through the workpiece, DO NOT USE the blade guard and splitter assembly.

Always return and fasten the blade guard and splitter assembly to its proper operating position for

normal through-sawing operations.

DO NOT USE the outside arbor flange with the moulding cutterhead. Tighten the arbor nut against the

cutterhead body. Keep the arbor flange handy because you will need it when you re-attach a blade to

the saw arbor.

DO NOT USE the standard table insert with the moulding cutterhead. USE ONLY the accessory

moulding cutterhead table insert (B) Fig. 50.

When using the moulding cutterhead, add wood-facing (C) to the face of the rip fence (Fig. 51). Attach the

wood-facing to the fence with wood screws through the holes provided in the fence. Stock that is 3/4" is suitable for most

work, although an occasional job may require 1" facing.

Position the wood-facing over the cutterhead with the cutterhead below the surface of the table. Turn the saw

“ON” and raise the cutterhead. The cutterhead will cut its own groove in the wood-facing (E) Fig. 51.

Never us the moulding cutterhead in a bevel position.

Never run the workpiece between the fence and the moulding cutterhead. Irregular shaped wood will

cause feedback.

When moulding the end grain, use the miter gauge. Slow the feed at the end of the cut to prevent splintering.

In all cuts, pay attention to the grain. Make your the cut in the same direction as the grain ,whenever possible.

Always install the blade guard after the operation is complete.

For certain cutting operations such as dadoing and moulding where you are not cutting

completely through the workpiece, DO NOT USE the blade guard and splitter assembly.

Always return and fasten the blade guard and splitter assembly to its proper operating position for

normal thru-sawing operations.

The maximum diameter for a dado head is 6" (152.4mm).

USING THE ACCESSORY DADO HEAD

Fig. 50

Fig. 51

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27

No comments

Delta TS300 Instruction Manual Page 20