Delta 36-725 Instruction Manual download pdf (Page 13)







1. To install throat plate, lower blade below tabletop,

then carefully feed the throat plate, slotted end

first, from the front of the table to the rear, keeping

the blade centered within the slot on the throat

plate. See Figure 8. The plate should rest within

the cavity in the tabletop.

2. Ensure that the throat plate is flush with the top of

the table.

3. If the throat is not flush with the tabletop, adjust

the height of the throat plate using the four set

screws (A).

 When installing riving knife, anti-kickback

pawls and blade guard, blade must be at 90° setting

and raised to the maximum height. See Raising and

Lowering Blade, page 16.



     



   



1. Your saw is shipped with the blade and riving knife

installed and properly aligned. The riving knife

comes installed in the low, non-through cutting

position. Prior to operating your saw, check to

make sure the alignment of the blade to the miter

slot and the riving knife to the blade was not



affected by shipping. To check alignment of the

blade and riving knife, see page 28 in the Alignment

section of this manual.

2. The riving knife comes installed in the low, non-

through cutting position. To attach the anti-

kickback pawls and blade guard assemblies, the

riving knife must be in the raised position as shown

in Figure 9. To raise and lower the riving knife, see

Riving Knife Height Settings on page 18.



     

 



1. Refer to Figure 9 and locate the anti-kickback

pawls mounting slot (A) in the middle of the top

edge of the riving knife.

2. Slide slot in the middle of the anti-kickback pawls

assembly along the top of the riving knife until the

stem (B) locates the center slot on the riving knife.

3. Depress the stem on the anti-kickback pawls

assembly (B) to allow the assembly to drop

into the slot. Push down on the anti-kickback

pawls assembly until it snaps into place and

locks. Release stem.   

     







To remove the anti-kickback pawls, depress the stem

(B) and pull the anti-kickback assembly off the riving

knife.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 63 64

Comments to this Manuals

No comments

Delta 36-725 Instruction Manual Page 13

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-725