Delta NANOTRACE DF-745 Instruction Manual download pdf (Page 3)

Read Me First…

Unpacking Procedure

Follow the procedure below to unpack your NanoTrace Moisture Analyzer

1. Examine the condition of the packaging and its contents. If any damage is

apparent, immediately notify the carrier and Delta F. Do not proceed with

the installation.

2. Check the contents against the packing slip to make sure the shipment is

complete. Unattached equipment may be shipped with the analyzer in

supplemental packaging. Shortages should be reported to Delta F

immediately.

3. All NanoTrace Moisture Analyzers are shipped with the following:

Item Delta F Part

Number

Power cord with 115 VAC connector

NOTE: No power cord is supplied with 220 VAC units

P/N 59017237

USB Memory Stick, Flash Drive (SONY USM512J) P/N 49600512

VCR Filter Gasket P/N 60300268

Aspirator P/N 14241410

Instruction Manual P/N 99000041

4. Open the analyzer door, remove any shipping materials and verify that

nothing has come loose during transit.

5. The analyzer is set at the factory to operate on 120 VAC or 240 VAC.

Examine the voltage indicator on the rear panel to verify that the voltage is

set as ordered.

6. Save the original container in the event you may need to ship the analyzer

to another location or back to the factory (see Shipping in the Service

section).

Installation and Maintenance

The NanoTrace Moisture Analyzer provides years of accurate and dependable

service if it is set up, operated and maintained properly. It is essential to make

a careful and complete installation as outlined in the Installation and Start Up

section of this manual. It is assumed that NanoTrace Moisture Analyzer users

are familiar with the techniques and precautions associated with Ultra-High

Purity (UHP) gas, its plumbing, and devices such as UHP regulators and gas

purifiers, and that the analyzer is used as designed and intended.

1 2 3 4 5 6 7 8 ... 97 98

No comments

Delta NANOTRACE DF-745 Instruction Manual Page 3