Delta 22-470 User Manual download pdf (Page 22)

ADJUSTING TABLE GIBS

In the unlikely event of the table developing unwanted

movement during planing operations, the table can be

checked and adjusted as follows:

1. DISCONNECT MACHINE FROM

POWER SOURCE.

2. With the table in the locked position, and with a feel-

er gage, measure the gap between table gib (A) Fig.

54 and table bracket (B). When set correctly the gap

should be .005 .

3. If an adjustment is necessary, loosen three locknuts

(C), and turn three adjustment screws (D) Fig. 54, as

necessary to set the correct gap.

4. Check and adjust the gap on the other side of the

table in the same manner. Tighten six locknuts, three

of which are shown at (C) Fig. 54, after adjustment is

made.

5. Raise and lower the table to its fullest range and

check to see if the table moves up and down with-

out binding.

Fig. 53

Fig. 52

Fig. 51

ADJUSTING TABLE HEIGHT SCALE

The table height scale indicates the distance the table is

from the cutting circle (depth of cut). To check and

adjust the pointer, proceed as follows:

1. Run a piece of wood through the planer and stop the

machine.

2. Measure the thickness of the planed end of the

stock as shown in Fig. 52. If an adjustment is nec-

essary, loosen screw (A) Fig. 53, adjust pointer (B)

and retighten screw (A).

5. If the table is not parallel to the cutterhead, lower boot

(B) Fig. 51, which is located underneath the table.

NOTE: Table elevating handwheel must be unlocked

when making this adjustment.

6. Loosen lock screw (C) Fig. 51, and with large pliers (D)

turn adjustment sleeve (E) as necessary until table is

paralell with the cutterhead. Tighten lock screw (C)

after adjustment is made and replace boot (B). NOTE:

The same adjustment can also be made on the other

side of the planer if necessary.

Fig. 54

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Delta 22-470 User Manual Page 22

Comments to this Manuals

Related products and manuals for Equipment Delta 22-470