Delta 36-444 Instruction Manual download pdf (Page 10)

MOTOR

The motor supplied with your saw is a 1-1/2 H.P. at 115 volts or 2 H.P. at 230 volts, Ball Bearing,

Capacitor Start/Capacitor Run, motor. This motor has been specially selected to best power your

machine and the relative safety of the machine is enhanced by its use. We, therefore, strongly suggest

that only this motor be used, as the use of other motors may be detrimental to the performance and

safety of the saw.

Fig. 12

ASSEMBLING MOTOR TO

MOTOR MOUNTING PLATE

WARNING: DISCONNECT MACHINE FROM

POWER SOURCE.

1. Assemble the motor (A) to the motor mounting plate

(B) as shown in Fig. 12, using four 5/16″ carriage bolts,

flat washers, star washers, and hex nuts (C)]. Assemble

bolts through holes, assemble flat washers, star

washers and hex nuts.

NOTE: Do not completely tighten hardware at this time.

Fig. 13

Fig. 15

Fig. 14

ASSEMBLING MOTOR

AND MOTOR MOUNTING

PLATE TO SAW

WARNING: DISCONNECT MACHINE FROM

POWER SOURCE.

1. Position motor and motor mounting plate (A) Fig. 13,

below bracket (B) to allow bracket arm to slide through

large opening in motor mounting plate (A).

2. Depress one plunger (C) Fig. 14 and connect one

side of motor mounting plate (A) to bracket (B). Then

depress other plunger (C) and rotate motor mounting

plate (A) until both plungers are engaged in holes (D) Fig.

13.

3. Fig. 15, illustrates the motor and motor mounting

plate assembled to the rear of the saw.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

No comments

Delta 36-444 Instruction Manual Page 10