Delta 36-444 Instruction Manual download pdf (Page 14)

Fig. 28

Fig. 29

Fig. 30

4. Using a straight edge, check to see if the top and

bottom of the inside splitter bracket (D) Fig. 28, is

aligned with the inner arbor flange (E), as shown.

5. When alignment is necessary, loosen the two

screws (F) Fig. 29, align bracket (D) with the arbor

flange and tighten screws (F).

6. Loosely assemble large washer and screw (C) Fig. 29,

to the inside splitter bracket. This screw and washer was

removed in STEP 3.

7. Assemble the blade guard and splitter assembly (G)

Fig. 30, between the large washer (C) and the splitter

bracket and tighten screw (H) with wrench supplied.

Fig. 32

Fig. 33

Fig. 31

8. Fasten the rear of the blade guard and splitter bracket

assembly (G) Fig. 31, to the rear splitter mounting

bracket using 5/16-18 x 5/8" carriage bolt (J) , flat

washer, and hex nut. Assemble carriage bolt through

hole, add flat washer then hex nut and tighten.

IMPORTANT: The splitter (G) Fig. 31, has a notch (L) cut

in the top edge as shown. This feature will enable the

blade guard to stay in the raised position to make blade

changing easier. Raise the front of blade guard (M) Fig.

32, until the rear edge of the blade guard slips into notch

(L) of splitter (G); the blade guard will stay in this

position.

9. With the blade guard (L) Fig. 33, in the raised

position, assemble the saw blade as shown at (K) on the

saw arbor (M) and tighten arbor nut (N) with two 7/8"

arbor wrenches supplied.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

No comments

Delta 36-444 Instruction Manual Page 14