Delta TP400LS Instruction Manual download pdf (Page 12)

RECOMMENDED

DEPTH OF CUT

NOTE: One revolution of the raising and lowering handle

will move the cutterhead up or down 3/32 of an inch.

A 3/32" depth of cut can be made in soft woods on

stock up to 8" wide and in hard woods on stock up to 7"

wide; see chart in Fig. 18.

For 10" and 12" wide soft wood, we recommend a maxi-

mum depth of cut of 1/16". For 10" and 12" wide hard

wood, a maximum depth of cut of 3/64" is recommended;

see chart in Fig. 18.

Fig. 18

DEPTH OF CUT

3/32"

1/16"

1/32"

SOFT WOOD

HARD WOOD

6" 8"

10"

12"

WIDTH OF STOCK

LEVELING

TABLE EXTENSIONS

The table extensions, one of which is shown at (A) Fig.

19, must be level with the planer table. To check and

adjust if necessary, proceed as follows:

DISCONNECT MACHINE FROM POWER

SOURCE.

1. Place a straight edge (B) Fig. 19, on the planer table

with one end of the straight edge extending out over the

infeed table extension (A) as shown. Check to see if the

table extension is level with the planer table on both

ends of table extension.

2. If an adjustment is necessary, loosen locknut (D) and

adjust stop screw (E) on each end of the table (A) until

table extension is level with planer table. Then tighten

locknut. Recheck and make certain inside edge of table

extension is level with planer table. NOTE: If necessary,

loosen two screws (C), adjust table extension and

tighten two screws.

3. Adjust opposite end of table extension (A) in the

same manner. Make sure table is solidly supported in

the level position.

4. Check and adjust outfeed table extension in the

same manner.

Fig. 19

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Comments to this Manuals

No comments

Delta TP400LS Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Power planers Delta TP400LS