Delta TP400LS Instruction Manual download pdf (Page 16)

9. Remove knife transfer tool and tighten the six

screws, five of which are shown at (F) Fig. 30, using

wrench (E) supplied.

10. Replace other knife by rotating head 180 degrees and

repeat STEPS 5 THROUGH 10.

11. Replace cutterhead guard (B) Fig. 31, making sure

cutterhead lock (D) is depressed and underneath guard

as shown. Slide guard in as far as possible and replace

two screws, one of which is shown at (A) Fig. 32. These

screws were removed in STEP 3.

ADJUSTING HEIGHT

OF OUTFEED ROLLER

DISCONNECT MACHINE FROM

POWER SOURCE.

1. The outfeed roller is adjusted at the factory to be

0.020" below the cutting circle. In order to check and

adjust the outfeed roller, you will need a homemade

gage block made of hardwood. This gage block can be

constructed by following the dimensions shown in

Fig. 33. NOTE: Make sure that the height of the block

is exactly 4 ".

Fig. 30

Fig. 31

Fig. 32

Fig. 33

1 2 ... 11 12 13 14 15 16 17 18 19 20 21

No comments

Delta TP400LS Instruction Manual Page 16