Delta 20-950 Instruction Manual download pdf (Page 10)

Place the drill press head (K) Fig. 15 on the column as far

as it will go. Align the head (K) Fig. 15 with the table (L) and

the base (M). Tighten the two head-locking screws (N) Fig.

16 with the 5mm wrench supplied.

Fig. 15

ATTACHING THE HEADSTOCK TO THE COLUMN

Fig. 16

IMPORTANT: Make certain the spindle taper (O) Fig. 18,

and tapered hole in chuck (P) are clean and free of any

grease, lacquer, or rust preventive coatings.

NOTE: Household oven cleaner can effectively remove any

substance from the chuck. However, carefully follow the

manufacturer's safety rules concerning its use.

IMPORTANT: Open the chuck jaws as wide as possible,

making sure that the chuck jaws are inside the chuck.

IMPORTANT: Make certain that the tapered hole in the

bottom of spindle (T) Fig. 17, and the taper on the spindle

adapter (U) are clean and free of grease, lacquer, or rust-

preventive coatings.

NOTE: Household oven cleaner can effectively remove these

coatings from the spindle and spindle adapter. However,

carefully follow the manufacturer’s safety rules regarding its

use.

Push the spindle adapter (U) Fig. 17 into the spindle (T).

making certain that the tang (V) engages the mating slot

inside the spindle (T).

Fig. 18

Fig. 17

RISK OF PROPERTY DAMAGE. To

avoid damage to the laser, prevent the cleaning solution

from coming in contact with the laser pod. You can

clean the laser pod with a dry cotton cloth.

INSTALLING THE CHUCK

RISK OF PERSONAL INJURY - The head-

sttock is very heavy. Use two or more people to place the

headstock on the column.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

No comments

Delta 20-950 Instruction Manual Page 10