Delta 441 Instruction Manual download pdf (Page 15)

Fig. 24

Fig. 25

Fig. 26

ASSEMBLING

BLADE GUARD AND

SPLITTER ASSEMBLY

DISCONNECT MACHINE FROM POWER

SOURCE.

1. Fasten the rear splitter mounting bracket (A) Fig. 24,

to the rear trunnion using the two 1/4-20 x 3/4" hex head

bolts (B) and flat washers. Do not completely tighten the

two bolts (B) at this time.

2. Raise saw arbor to its highest position. With

wrenches supplied, remove the saw blade from the saw.

Refer to section “CHANGING THE SAW BLADE” of this

manual.

3. Remove bolt and large washer (C) Fig. 25, from the

inside splitter mounting bracket.

4. Use a straight edge (E) to check to see if the top and

bottom of the inside splitter bracket (D) Fig. 26 is aligned

with the inner arbor flange (F).

ASSEMBLING AND ALIGNING

BLADE GUARD AND SPLITTER ASSEMBLY

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

No comments

Delta 441 Instruction Manual Page 15