Delta 900585 Instruction Manual download pdf (Page 3)

1. DO NOT operate your drill press until it is

completely assembled and installed according to the

instructions.

2. IF YOU ARE NOT thoroughly familiar with the

operation of drill presses, obtain advice from your

supervisor, instructor or other qualified person.

3. YOUR DRILL PRESS MUST be securely fastened

to a stand or workbench. If there is any tendency for the

stand or workbench to move during operation, the stand

or workbench MUST be fastened to the floor.

4. NEVER turn the drill press “on” before clearing the

table of all objects (tools, scrap pieces, etc.).

5. NEVER start the drill press with the drill bit or cutting

tool in contact with the workpiece.

6. USE ONLY drill bits, cutters, sanding drums and

other accessories with 1/2" shank diameter or less.

7. ALWAYS keep hands and fingers away from the drill

bit or cutting tool.

8. DO NOT ATTEMPT to drill material that does not

have a flat surface, unless a suitable support is used.

9. AVOID awkward hand positions where a sudden slip

could cause a hand to move into the drill bit or cutting

tool.

10. TO PREVENT ROTATION OF THE WORKPIECE,

ALWAYS clamp work securely to table if it is too short to

contact the column (see “OPERATION” section of this

manual) or when using hole saw or cutting tools larger

than 1/2 in diameter.

11. USE recommended speed for drill, accessory or

workpiece material.

12. MAKE CERTAIN all lock handles are tightened

before starting the machine.

13. NEVER perform layout, assembly or set-up work on

the table while the tool is operating.

SAVE THESE INSTRUCTIONS.

ADDITIONAL SAFETY RULES

FOR DRILL PRESSES

14. BE SURE drill bit or cutting tool is not damaged and

is properly locked in the chuck before operating.

15. MAKE SURE chuck key is removed from chuck

before starting drill press. ONLY use chuck key provided

with your drill press. It is equipped with a self-ejecting

pin which eliminates the hazard of the key being left in

the chuck.

16. ADJUST the table or depth stop to avoid drilling into

the table.

17. ALWAYS allow the drill press to stop before removing

scrap pieces from the table.

18. WHEN drilling large workpieces, MAKE SURE the

material is supported at table height.

19. SHUT OFF the power, remove the drill bit or cutting

tool, and clean the table and work area before leaving

the machine.

20. DON'T wear gloves, necktie, or loose clothing when

operating the drill press.

21. WHEN THE TOOL IS NOT IN USE the switch should

be locked in the “OFF” position to prevent unauthorized

use of the tool.

22. SHOULD any part of your drill press be missing,

damaged or fail in anyway, or any electrical component

fail to perform properly, shut off machine and remove

plug from power supply outlet. Replace missing,

damaged or failed parts before resuming operation.

23. ADDITIONAL INFORMATION regarding the safe

and proper operation of this product is available from

the National Safety Council, 1121 Spring Lake Drive,

Itasca, Illinois 60143-3201, in the Accident Prevention

Manual for Industrial Operations and also in the Safety

Data Sheets provided by the NSC. Please also refer to

the American National Standards Institute ANSI 01.1

Safety Requirements for Woodworking Machinery and

the U.S. Department of Labor OSHA 1910.212 and

1910.213 Regulations.

1 2 3 4 5 6 7 8 ... 15 16

Comments to this Manuals

No comments

Delta 900585 Instruction Manual Page 3

Comments to this Manuals

Related products and manuals for Power tools Delta 900585