Delta 28-190 Instruction Manual download pdf (Page 6)

ASSEMBLING STAND

AND RUBBER FEET

1. Assemble the stand, as shown in Fig. 3, using the

32 carriage bolts, flat washers and nuts supplied. The

two 12-3/4" long upper braces (J); 21-1/2" long upper

braces (K); 17" long lower braces (L) and 25-3/4" long

lower braces (M) should be fastened to the four 26-1/4"

long legs (B). IMPORTANT: The top lips of the upper

braces (J) should be on top of the top lips of upper

braces (K).

2. Assemble the four rubber feet (E) Fig. 3, to bottom of

each leg (B) as shown.

ASSEMBLY INSTRUCTIONS

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE BAND SAW TO THE POWER

SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ AND

UNDERSTOOD THE ENTIRE OWNERS MANUAL.

ASSEMBLING BAND SAW

TO STAND

1. Fig. 4 illustrates the two through holes (A) and two

threaded holes (C) which will be used to secure the band

saw to the stand.

2. Place the band saw on top of stand and line up the

two threaded holes (C) Fig. 4, with the two holes (D) Fig.

5, on upper brace of stand.

Fig. 5

Fig. 4

Fig. 3

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

No comments

Delta 28-190 Instruction Manual Page 6