Delta 28-190 Instruction Manual download pdf (Page 8)

Fig. 11

Fig. 10

3. Replace screw (A) Fig. 10, flat washer (B) and wing

nut (C) that was removed in STEP 1.

ASSEMBLING UPPER

BLADE GUIDE ASSEMBLY

1. Fasten the upper blade guide assembly (A) Fig. 11,

to the side of the band saw using the lock plate (B) and

lock screw (C) as shown.

Fig. 12

TOTAL LENGTH OF

CORD IN FEET

GAGE OF EXTENSION

CORD TO USE

16 AWG

14 AWG

12 AWG

0-25

26 - 50

51 - 100

101 - 150

EXTENSION CORDS

Use proper extension cords. Make sure your extension cord is in good

condition and is a 3-wire extension cord which has a 3-prong ground-

ing type plug and a 3-pole receptacle which will accept the tools plug.

When using an extension cord, be sure to use one heavy enough to

carry the current of the band saw. An undersized cord will cause a

drop in line voltage resulting in loss of power and overheating. Fig. 12,

shows the correct size to use depending on cord length and

nameplate ampere rating. If in doubt, use the next heavier gage. The

smaller the gage number, the heavier the cord.

1 2 3 4 5 6 7 8 9 ... 18

No comments

Delta 28-190 Instruction Manual Page 8