Delta 28-190 Instruction Manual download pdf (Page 7)

Fig. 6

Fig. 7

Fig. 9

Fig. 8

4. Fasten remaining end of band saw to top of stand

using two 45mm (approximately 1-3/4″ long) hex head

screws (F) Fig. 7, four flat washers (G), and two hex nuts

(H) supplied as shown. NOTE: On the foot end of band

saw the screw and flat washer (F) and (G) are inserted

from the top and the nut and remaining flat washer are

under the upper brace of the stand. On the motor end of

band saw, the nut and flat washer (H) and (G) will be

located on the top of the motor mounting plate, as

shown.

3. Using the two 45mm (approximately 1-3/4" long)

screws (E) Fig. 6, and flat washers supplied, fasten the

band saw to the stand by threading the two screws (E)

into the tapped holes in bottom of saw as shown.

ASSEMBLING TABLE

1. Remove the screw (A) Fig. 8, flat washer (B) and wing

nut (C) from slotted end (D) of table and slide table (E)

into position on band saw as shown.

2. Fasten table bracket (F) Fig. 9, to band saw frame

using the 70mm (approximately 2-3/4" long) screw (G)

and flat washer and the two 15mm (approximately 5/8"

long) screws (H) and flat washers as shown.

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

No comments

Delta 28-190 Instruction Manual Page 7