Delta CL180CS Instruction Manual download pdf (Page 9)

Fig. 2

Fig. 3

Depending on room temperature, line voltage, and existing charge level, initial

battery charging may take longer than one hour. Disconnect charger from power

source when not in use.

Special Charge Modes: If all lights go out after the battery is inserted, the

charger has entered pre-charge mode. In approximately 5-10 minutes, the

orange and red lights should turn on indicating that fast charge has been initi-

ated. If all lights remain off after 15 minutes, remove the battery. The orange

light should glow. Reinsert the battery. If the orange light goes out when the bat-

tery is inserted and all lights remain off for 15 minutes, battery should be

replaced.

After inserting battery, if the orange light is on while the red and green lights

remain off, remove battery and re-insert. If the orange light is on while the red

and green lights remain off, battery should be replaced.

INSTALLING OR REMOVING BATTERY PACK

TO INSTALL BATTERY PACK: Align

rails (A) Fig. 4, on battery pack with

slots on tool and push battery pack

onto tool until it locks in place.

TO REMOVE BATTERY PACK:

Depress the battery release button

(B) Fig. 4, and pull battery pack out of

tool.

Fig. 4

STARTING AND STOPPING

THE SAW

This tool is always

in an operating condition because

it does not have to be plugged

into an electrical outlet. Keep

hands, body, and clothing clear of

the blade when a battery pack is

installed in the saw.

The trigger switch is equipped with

a “lock-off” button (A) Fig. 5. This

“lock-off” button extends through

OPERATING AND ADJUSTMENTS

Fig. 5

the upper handle area, and may be depressed from either the left or the right

side of the handle. Depress either end of this button to release the “lock-off”

feature, allowing the trigger switch to be engaged.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Delta CL180CS Instruction Manual Page 9