Delta RS830 Instruction Manual download pdf (Page 9)

CARTON CONTENTS

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from

all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone,

gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household

floor paste wax.

Fig. 1

Fig. 2 Fig. 3

1. The saw is packed at the factory with support

blocks (A) Fig. 1, under the cutter-head (B), and track

arm (C). Shipping boards (D) Fig. 1 are fastened to saw

base (G). To prevent damage during shipment, the track

arm elevating knob (H) is disassembled from lever (E).

Before proceeding, insert post of knob (H) Fig. 2,

through hole in lever (E) and assemble E-ring (K), to slot

in post.

2. The support blocks (A) Fig. 1, can be removed by

rotating track arm elevating knob (H) clockwise and the

shipping boards (D) can be removed by removing hold-

down screws (not shown), which are located inside saw

base. Discard the support blocks (A) and shipping boards

(D).

3 Fig. 3, illustrates the saw with support blocks and

shipping boards removed.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 32 33

No comments

Delta RS830 Instruction Manual Page 9