Delta RS830 Instruction Manual download pdf (Page 13)

11. Place an arbor wrench (D) Fig. 25, between table

board (A) and motor shaft (B). Lower track arm (X)

Fig. 24, by turning elevating handle (C) counterclockwise

until motor shaft (B) Fig. 25, barely touches arbor

wrench.

Fig. 25

Fig. 26

Fig. 27

Fig. 28

12. Check the height of the table board above the other

three table board adjustment screws (E) Fig. 26, by re-

positioning track arm (X), and cutting-head assembly (V)

until the highest point of the table is determined. NOTE:

MAKE CERTAIN CUTTING-HEAD CLAMP KNOB (W)

FIG. 27 AND TRACK ARM CLAMP HANDLE (Y) ARE

TIGHTENED WHEN MOTOR SHAFT IS LOCATED

ABOVE EACH OF THE ADJUSTMENT SCREWS. DO

NOT CHANGE HEIGHT OF TRACK ARM (X) FIG. 26,

UNTIL HIGHEST SCREW IS DETERMINED, AND ALL

FOUR CORNERS OF THE TABLE BOARD HAVE BEEN

ADJUSTED.

13. Position the motor shaft back over the three lower

corners of the table board and adjust the table

adjustment screws (E) Fig. 26, until the arbor wrench fits

accordingly between the arbor shaft and table board in

each location.

14. Once the table board (A) Fig. 28, is properly ad-

justed, tighten three screws (G) on each side of saw

base (H). Then return track arm (X) and motor (V) to the

90 degree position as shown, and tighten bevel clamp

lever (S) and track arm clamp handle (Y) Fig. 27.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

No comments

Delta RS830 Instruction Manual Page 13