Delta 36-220 Service Manual download pdf (Page 13)

--- 10 ---

(6) Compound (miter + bevel) cutting

Compound cutting can be accomplished by combining the miter cutting and bevel cutting operations described

in paragraphs (4) and (5) above. (For details, please refer to the Instruction Manual.)

When the saw blade section (head) is inclined 45 to the left, the table can be turned up to 45 to the right and

left.

(7) Cut surface quality during miter/bevel cutting

The quality of the cut surface depends on the type of

cutting operation (miter or bevel), the type and

sharpness of the saw blade, whether the workpiece

is cut to the right or left, and various other factors. In

miter and bevel cutting in particular, cutting is

performed across the wood grain, so the condition of

the cut surface depends on whether the wood is cut

with or against the grain. This is the sames as when

using electric portable planers. Customers should

be advised of these phenomena so that they

understand that in cases when the cut surface may

not be as smooth as expected or hoped for, it is not

caused by the performance of the saw blade or the

Model C 10FC2.

In the cutting examples illustrated in Fig. 9, the cut

surfaces on the sides marked A are better than

those on the sides marked B .

[Miter cutting]

Better

[Left bevel cutting]

Better

Fig. 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 34 35

No comments

Delta 36-220 Service Manual Page 13