Delta 36-220 Service Manual download pdf (Page 15)

--- 12 ---

11. PRECAUTIONS IN DISASSEMBLY AND REASSEMBLY

11-1. Disassembly

Special attention in disassembly should be given to the following items.

The circled numbers in the following figures and the [Bold] numbers in the descriptions below correspond to the

item numbers in the Parts List and the exploded assembly diagram.

Be sure to first disconnect the power plug when performing disassembly and replacement of the saw blade.

Item

No.

Disassembly

spots

Disassembly procedure Necessary tools

1 Link

Blade guard

701

702

Fig. 12

1. Remove the Truss Hd. Screw 1/4" x 1/2" [1] and then remove the

Link [2].

2. Remove the Machine Screw M5 x 16 [3] and remove the washer

3/16" x 3/4" [4], the Collar [5], the Guard Retainer [6], the Blade

Guard (Plastic) [7] and the Spring Guard [8].

3. Loosen the Flat Hd. Screw 32 UNF x 13/16" [20] and rotate the

Cutter Shaft Guard [28] until the Bolt (Left Hand) W/Washer M8 x

20 [11] can be seen.

4. Put the Wrench [701] on the Bolt (Left Hand) W/Washer M8 x 20

[11] and turn the Wrench [701] until the Bracket Stop [25] is

aligned with the groove of the Shaft Arbor [112] (See Fig. 16)

while pushing the Bracket Stop [25].

Then, loosen the Bolt (Left Hand) W/Washer M8 x 20 [11] and

remove the Bolt (Left Hand) W/Washer M8 x 20 [11], the Washer

[12], the outside Arbor Collar [13], the TCT Saw Blade [702] and

the inside Arbor Collar [13].

5. Remove the three Hex. Socket Hd. Bolts M5 x 20 [14] and the

Blade Guard (Metal) [19].

Phillips

Screwdriver

Wrench

4 mm Hex. bar

wrench

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 34 35

No comments

Delta 36-220 Service Manual Page 15