Delta 36-220 Service Manual download pdf (Page 24)

--- 21 ---

(4) Reassembly of the Table [60]

When reassembling the Table [60] and the Base [74], tighten the Chuck Nut M8 [58] so that the Table [60]

turns smoothly without excessive play or vibration.

During reassembly, liberally apply grease (Hitachi Motor Grease No. 29, Code No. 930035 is recommended.)

at the point marked A in Fig. 23.

Chuck Nut M8 [58]

Table [60]

Base [74]

Center Shaft [75]

Fig. 23

11-7. Lubrication

Advise the customer to lubricate the machine as indicated below at least once a month. Also, prior to applying

lubrication, any sawdust, dirt or other foreign matter should be thoroughly wiped away with a soft cloth.

(1) Swiveling section of the Arm [120] and the Angle Regulator [32]

Coat the swiveling portion of the Arm [120] and the Angle Regulator [32] with machine oil.

(2) Vise ass'y section

Coat the screw threads portion of the Handle Bar [105] of the Vise Ass'y [102] with machine oil.

11-8. Product Precision

On completion of reassembly, confirm precision tolerances.

Run-out of saw blade (or dummy disc)

Perpendicularity between base and fence

Perpendicularity between saw blade (or dummy disc) and fence

Perpendicularity between saw blade (or dummy disc) and table

Item

Tolerance

Unit : mm

0.38/220 (0.015" / 8-21/32")

0.34/80 (0.013" / 3-5/32")

0.45/100 (0.018" / 4")

0.3/70 (0.012" / 2-3/4")

0.45 ( 0.018")

Surface alignment of

base and table (Use

the upper surface of

the base as a

reference).

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 34 35

No comments

Delta 36-220 Service Manual Page 24