Delta 36-953 Instruction Manual download pdf (Page 25)

Fig. 68

SPECIAL ATTENTION SHOULD BE

GIVEN THE GRAIN DIRECTION. MAKE ALL CUTS IN

THE SAME DIRECTION AS THE GRAIN WHENEVER

POSSIBLE.

ALWAYS INSTALL BLADE GUARD

AFTER OPERATION IS COMPLETE.

Fig. 69

Fig. 70

Fig. 71

1. Dadoing is cutting a rabbet or wide groove into the

work. Most dado head sets are made up of two outside

saws and four or five inside cutters, (Fig. 69). Various

combinations of saws and cutters are used to cut

grooves from 1/8″ to 13/16″ for use in shelving, making

joints, tenoning, grooving, etc. The cutters are heavily

swaged and must be arranged so that this heavy portion

falls in the gullets of the outside saws, as shown in Fig.

70. The saw and cutter overlap is shown in Fig. 71, (A)

being the outside saw, (B) an inside cutter, and (C) a

paper washer or washers, used as needed to control the

exact width of groove. A 1/4″ groove is cut by using the

two outside saws. The teeth of the saws should be

positioned so that the raker on one saw is beside the

cutting teeth on the other saw.

2. Attach the dado head set (D) Fig. 72, to the saw arbor.

NOTE: THE OUTSIDE ARBOR FLANGE CAN NOT BE

USED WITH THE DADO HEAD SET, TIGHTEN THE

ARBOR NUT AGAINST THE DADO HEAD SET BODY.

DO NOT LOSE THE OUTSIDE ARBOR FLANGE. IT

WILL BE NEEDED WHEN REATTACHING A BLADE TO

THE ARBOR.

THE ACCESSORY DADO HEAD SET

TABLE INSERT (E) FIG. 72, MUST BE USED IN PLACE

OF THE STANDARD TABLE INSERT.

THE BLADE GUARD AND SPLITTER

ASSEMBLY CANNOT BE USED WHEN DADOING AND

MUST BE REMOVED OR SWUNG TO THE REAR OF

THE SAW AS EXPLAINED PREVIOUSLY IN THIS

MANUAL. AUXILIARY JIGS, FIXTURES, PUSH STICKS

AND FEATHER BOARDS SHOULD ALSO BE USED.

THE BLADE GUARD AND SPLITTER

ASSEMBLY CANNOT BE USED WHEN DADOING OR

MOULDING. IT MUST BE REMOVED OR SWUNG TO

THE REAR OF THE SAW AS DESCRIBED IN “USING

ACCESSORY MOULDING CUTTERHEAD” SECTION.

AUXILIARY JIGS, FIXTURES, PUSH

STICKS AND FEATHER BOARDS SHOULD BE USED.

ACCESSORY DADO HEAD

Fig. 72

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Delta 36-953 Instruction Manual Page 25

Comments to this Manuals

Related products and manuals for Mitre saws Delta 36-953