Delta MS250 Instruction Manual download pdf (Page 9)

For your own safety, do not connect the machine to the power source until the machine is completely

assembled and you read and understand the entire instruction manual.

ATTACHING THE MITER SAW ARM TO THE BASE

1. Align the bevel lock handle screw (A) Fig. 2 on the miter saw

arm with the bevel hub (B) on the base.

2. Thread the bevel lock handle screw (A) Fig. 2 into the bevel

hub (B) by turning the bevel handle knob (K) Fig. 3.

ATTACHING THE BEVEL POINTER

1. Loosen the bevel lock handle (K) Fig. 3, and tilt the miter saw

arm to the 45 degree position.

2. Align the hole in the bevel pointer (C) Fig. 3 with the hole (D)

in the back of the base.

3. Insert the M5x.8x10mm pan head screw with washer (B)

Fig. 3 through the hole in the bevel pointer (C). Thread the

screw into the hole (D) in the back of the base and tighten

securely.

NOTE: To adjust the pointer, see the section “ADJUSTING 90

AND 45

° BEVEL STOPS”.

Thread the table lock handle (A) Fig. 4 into the threaded hole (B)

of the arm bracket.

1. Turn the table lock handle (A) Fig. 5 counter-clockwise one

or two turns, and depress the index lever (B) to release the

45° positive stop.

DISCONNECT MACHINE FROM POWER SOURCE!

Fig. 2

Fig. 3

Fig. 4

DISCONNECT MACHINE FROM POWER SOURCE!

ATTACHING THE TABLE LOCK HANDLE

ROTATING THE TABLE TO THE 90° DEGREE POSITION

Fig. 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

No comments

Delta MS250 Instruction Manual Page 9