Delta 31-340 Instruction Manual download pdf (Page 12)

Fig. 27

The table can be tilted 45 degrees to the front, as shown

in Fig. 27, by loosening lock lever (B). Using a

combination square (E) check to see if the table is at 45

degrees to the belt and tighten lock lever (B).

WARNING: TO AVOID TRAPPING THE WORK OR

FINGERS BETWEEN THE TABLE AND SANDING

BELT, THE TABLE EDGE (C) SHOULD BE

POSITIONED A MAXIMUM OF 1/16 INCH FROM THE

SANDING BELT (D) WHEN THE TABLE IS TILTED.

DISC TABLE ADJUSTMENTS

The disc table (A) Fig. 28, can be tilted 45 degrees up or

down, by loosening lock handle (B), tilting the table, and

tightening lock handle (B). NOTE: The lock handle (B) is

spring-loaded and can be repositioned by pulling out the

handle (B) and repositioning it on the serrated locking

stud located directly underneath the handle.

WARNING: TO AVOID TRAPPING THE WORK OR

FINGERS BETWEEN THE TABLE AND SANDING

DISC, THE SANDING DISC (C) SHOULD BE

ADJUSTED SO IT IS A MAXIMUM OF 1/16 INCH

FROM EDGE OF TABLE (D). This can be accomplished

by moving the sanding disc in or out on the motor shaft.

To check and see if the table is at 90 degrees to the

sanding disc, place a square (E) Fig. 29, on the table with

one end of the square against the sanding disc, as

shown. If an adjustment is necessary, loosen lock lever

(B), move table until you are certain it is at 90 degrees to

the sanding disc and tighten lock lever (B).

Then loosen screw (F) Fig. 30, and adjust pointer (G) so

it points to the “0” degree mark on the table scale.

Fig. 28

Fig. 29

Fig. 30

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Delta 31-340 Instruction Manual Page 12