Delta 31-340 Instruction Manual download pdf (Page 13)

Fig. 31

Fig. 32

REMOVING AND

INSTALLING

ABRASIVE BELTS

1. DISCONNECT MACHINE FROM POWER SOURCE.

2. Unscrew and remove the two knobs (A) Fig. 31, and

remove the side cover (B) from the belt unit.

3. Press down on the tracking knob to release belt

tension and remove belt (C) Fig. 32, from the three

pulleys (D), as shown.

4. Install new 1" x 42" belt and replace side cover.

Check belt tracking by referring to the section

“TRACKING THE SANDING BELT,” and adjust if

necessary. IMPORTANT: Some belts have a directional

arrow printed on the inside of the belt. In these cases the

belt must be installed so the directional arrow is in the

same direction that the machine is running. The sanding

belt travels down at the front of the machine.

REMOVING AND

INSTALLING ABRASIVE

DISCS

1. DISCONNECT MACHINE FROM POWER SOURCE.

2. Remove the sanding disc table.

3. Remove the old abrasive disc by peeling it from the

sanding disc plate.

4. Clean the disc plate thoroughly.

5. Remove the backing from the new abrasive disc and

press the abrasive disc firmly onto the disc plate.

6. Replace the sanding disc table.

Fig. 33

Fig. 34

MITER GAGE

A miter gage (A) Fig. 33, is supplied with your sander and

can be used on the disc table, as shown, or on the belt

table. The miter gage can be set anywhere up to 45

degrees right or left by loosening lock knob (B), tilting

miter gage body (C) to the desired angle and tightening

lock knob (B).

DUST CHUTES

Two dust chutes are supplied with your belt and disc

sander and are equipped with 1-1/4 inch I.D. openings

that can easily be connected to a dust collection system.

Dust chute (A) Fig. 34, is for the belt unit and dust chute

(B) is for the disc unit.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Delta 31-340 Instruction Manual Page 13

Comments to this Manuals

Related products and manuals for Power sanders Delta 31-340