Delta 22-580 Instruction Manual download pdf (Page 18)

You will need to clean the infeed and outfeed rollers (M)

Fig. 40 periodically. Use soap, water, and a scotch-brite

pad.

To periodically lubricate the gears in the gear box, the feed roller bushings, and the spindles and columns:

LUBRICATION

1. Remove the two top covers (A) Fig. 36.

2. Remove the screw (B) Fig. 38. Remove the depth stop assembly.

3. Remove the two 6mm screws (C) Fig. 36.

4. Lift the top left machine cover (D), and pull out the side cover (E) Fig. 36.

5. Remove the two screws (F) Fig. 37 and remove the gear housing cover (D) Fig. 37.

6. Place extreme pressure lithium grease on the gear teeth (H) Fig. 38. Replace the gear housing cover.

7. Clean and oil the columns (J) Fig. 38 and the spindles (K) with a light-weight machine oil.

8. Reassemble the planer.

9. Place the planer on its back and put oil on the feed roller bushings (L) Fig. 41, two of which are shown, at each

end of the feed rollers.

DISCONNECT TOOL FROM POWER SOURCE!

Fig. 36

Fig. 37

Fig. 38

CLEANING INFEED AND OUTFEED ROLLERS

Fig. 40

LUBRICATING THE BEARING BLOCKS

Position the machine on its end (Fig. 39). Place 2 drops of 30 weight oil on the shaft (A) Fig. 40 at the bearing block

(B). Allow the oil to flow into the bearing block.

Fig. 39

1 2 ... 13 14 15 16 17 18 19 20 21

No comments

Delta 22-580 Instruction Manual Page 18