Delta 22-580 Instruction Manual download pdf (Page 9)

Use the supplied wrench to attach the cutterhead lock handle (A) Figs. 3 & 4, to the shaft (B) with the M6-20mm hex

socket-head screw (C) Fig. 4.

1. Attach the cutterhead adjustment handle (A) Fig. 6 to the shaft (B), making certain that the flat on the shaft is

engaged with the flat in the handle.

2. Fasten the cutterhead adjustment handle (A) Fig. 7 to the shaft using the M5 x 16mm hex socket-head screw (C)

with the hex end of the supplied cutterhead wrench.

3. Rotate handle (A) to the operating position as shown in Fig. 8.

The infeed and outfeed table extensions (A) Fig. 3 are

shipped in the “UP” position on the machine. Lower

both table extensions (A) to the "DOWN" position

(Fig. 3). To check and adjust the top surface of the table

extensions (A) level with the planer table, refer to the

section of this manual entitled “LEVELING TABLE

EXTENSIONS.”

Fig. 3

Fig. 4

CUTTERHEAD LOCK HANDLE

CUTTERHEAD ADJUSTMENT HANDLE

LOWERING THE EXTENSION TABLES

Fig. 5

Fig. 6

Fig. 7

Fig. 8

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

No comments

Delta 22-580 Instruction Manual Page 9