Delta 9159T-DST Installation Guide

HIGH-RISE, PULL-DOWN KITCHEN AND BAR / PREP, TOUCH FAUCETSLLAVES DE AGUA – GRIFOS DE CUELLO CISNE EXTRAÍBLES DE FUNCIÓN AL TACTO PARA COCINA Y BAR/PRE

B.1070530 Rev. D5A.A. Connect battery cable (1) to battery box (2). Install 6 “AA” batteries (3) into the battery box (2). Important: DO NOT install

1170530 Rev. D223D.412C.OROOU314D. Custom Fit ConnectionsIf you determine the PEX supply tubing for this faucet is too long and must be shorter to

1270530 Rev. DEnsure cut is straight.Do not install sleeve upside down.Do not use RP51243 gasket (1) supplied with PEX tubing or brass ferrule (2)

7A. Turn on hot and cold water supplies (1). Pull the hose assembly (2) out of the spout. Be sure to hold the end of the hose down into the sink and

1470530 Rev. DIf faucet exhibits very low flow –Unscrew hose from spray head and clean debris from screen (1) (the screen is located just inside the

SHUT OFF WATER SUPPLIES. Check and clean screen (1) located in solenoid valve (2).CIERRE LOS SUMINISTROS DE AGUA. Compruebe y limpie la pantalla (1) s

1670530 Rev. DSolenoid Troubleshooting1. If your spout flashes a red light on then off and then keeps repeating this, replace the batteries. If

270530 Rev. D© 2012 Masco Corporación de IndianaPiezas y acabadoTodas las piezas (excepto las piezas electrónicas y las pilas) y los acabados de est

370530 Rev. DRP49149Steel Weight AssemblyEnsamble de la Pesa de Acero Masselotte en acier RP71655▲ Kitchen Spout Assembly with MagnetEnsamble del T

RP60520 Adapter & O-RingAdaptador y Aro-OAdaptateur et joint toriqueRP64462Solenoid AssemblyEnsamble de SolenoideÉlectrovanneRP13938O-Ring (2)Anil

570530 Rev. D1Spout Installation For Top Mount SinksA. Your faucet is designed for a hole diameter of 1 3/8" +/- 1/8" (35 mm +/- 3 mm) a

670530 Rev. D11 1/4" Min. From Center Line To Sink Bowl.1 1/4" Mínimo. De la línea de centro para hundir el tazón de fuente.1 1/4" ;

770530 Rev. D2Optional Escutcheon InstallationFor optional installations using the 10 1/2" escutcheon, order RP64070 not supplied (specify fini

B.B. Push hose end (1) onto solenoid assembly outlet (2). Attach clip (3) over hoses as shown. Pull down moderately to ensure connection has been ma

4B.Wire ConnectionsConexiones de AlambreBranchement des filsA. Briefly touch the cold stop or other ground with hand to dissipate any static charge. A