Delta 36-220 Instruction Manual download pdf (Page 10)

Fig. 17

Fig. 16

Fig. 15

ROTATING TABLE

FOR MITER CUTTING

Your compound miter saw will cut any miter angle from a

straight 90 degree cut-off to 47 degrees right and left.

Simply loosen lock handle (A) Fig. 14, depress index

lever (B) and move the control arm to the desired angle.

Then tighten lock handle (A).

The 10" Compound Miter Saw is equipped with positive

miter stops for the table control arm at the 0, 15, 22-1/2,

30 and 45 degree right and left positions. Simply loosen

lock handle (A) Fig. 14, and move the control arm until

the spring loaded index lever (B) engages into one of the

positive stops (four of which are shown at (C) ). Then

tighten lock handle (A). To disengage the positive stop,

depress index lever (B). IMPORTANT: ALWAYS TIGHT-

EN LOCK HANDLE (A) BEFORE CUTTING.

In addition, two triangle indicators (D) Fig. 15, are provid-

ed on the scale at the 31-5/8 degree right and left miter

angle for cutting crown moulding. Refer to the CUTTING

CROWN MOULDING section of this manual.

TILTING CUTTING ARM

FOR BEVEL CUTTING

The cutting arm of your compound miter saw can be tilt-

ed to cut any bevel angle from a 90 degree straight cut-

off to a 45 degree left bevel angle by loosening bevel lock

handle (A) Fig. 16, tilting cutting arm to the desired angle

and tightening lock handle (A). NOTE: Lock handle (A) is

spring loaded and can be repositioned by pulling out on

the handle and repositioning it on the nut located under-

neath the hub of the handle.

Positive stops are provided to rapidly position the saw

blade at 90 and 45 degrees to the table. The bevel angle

of the cutting arm is determined by the position of the

pointer (B) Fig. 16, on the scale (C).

In addition, a triangle indicator (D) Fig. 17, is provided on

the sale at the 33-7/8 degree bevel angle for cutting

crown moulding. Refer to the CUTTING CROWN

MOULDING section of this manual.

Fig. 14

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

No comments

Delta 36-220 Instruction Manual Page 10