Delta 36-220 Instruction Manual download pdf (Page 15)

Fig.31

Fig. 32

Fig. 33

ADJUSTING DOWNWARD

TRAVEL OF SAW BLADE

1. DISCONNECT THE SAW FROM THE POWER

SOURCE.

2. The downward travel of the saw blade can be limited

to prevent the saw blade from contacting any metal sur-

faces of the machine. This adjustment is made by loos-

ening locknut (A) Fig. 31, and turning adjusting screw (B)

in or out.

3. When making this adjustment, make sure the

machine is disconnected from the power source and

lower the blade as far as possible. Rotate the blade by

hand to make certain the teeth do not contact any metal

surfaces.

7. Fig. 32, illustrates the fence in the rear position

enabling you to cross-cut a standard 2 x 6 in one pass.

8. Fig. 33, illustrates the stock stop (A) being used for

repetitive cutting operations.

TYPICAL OPERATIONS AND HELPFUL HINTS

1. Before cutting, make certain the miter and bevel angles are set and firmly locked in place.

2. Before cutting, determine that the workpiece is the right size for the saw.

3. Place the workpiece on the table and hold it firmly against the fence.

4. For best results cut at a slow, even cutting rate.

5. If the workpiece you are cutting causes your hand to be within 4 inches of the saw blade the

workpiece must be clamped to the fence before cutting.

6. Never attempt any freehand cutting (wood that is not held firmly against the fence and table).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

No comments

Delta 36-220 Instruction Manual Page 15