Delta 36-220 Instruction Manual download pdf (Page 16)

Fig. 34

Fig. 35

Fig. 36

9. Fig. 34, illustrates the work clamp (B) being used to

firmly hold the workpiece against the fence.

10. Fig. 35, illustrates the cuttinghead tilted and the arm

in a miter position for a compound miter/bevel cutting

operation.

11. Fig. 36, illustrates the fence in the forward position

enabling you to cross-cut a standard 4 x 4 in one pass.

CUTTING CROWN MOULDING

One of the many features of your saw is the ease of cutting crown moulding. The following is an

example of cutting both inside and outside corners on 52/38 degree wall angle crown moulding.

NOTE: When cutting 45 degree wall angle crown moulding the following procedure for inside and

outside corners is the same with the exception that the bevel position will always be at 30 degrees

and the miter position will be 34-1/4 degrees to the right or left.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23

No comments

Delta 36-220 Instruction Manual Page 16