Delta 100 Series Installation Manual download pdf (Page 52)

IQ 100 Series (130/140/150) Meter

Programming the Meter Using the Front Panel

52 User and Installation Manual IM02601003E-September 2011 www.eaton.com

Entering a Password

If Password protection has been enabled in the software for reset and/or conguration (see page 66 for

information), a screen appears requesting a password when you try to reset the meter and/or congure

settings through the front panel.

• PASS appears in the A window and 4 dashes appear in the B window. The leftmost dash is

ashing.

1. Press the Down button to scroll numbers from 0 to 9 for the ashing dash. When the correct number

appears for that dash, use the the Right button to move to the next dash.

Example: The left screen, below, shows four dashes. The right screen shows the display after the

rst two digits of the password have been entered.

2. When all 4 digits of the password have been selected, press the Enter button.

• If you are in Reset mode and the correct password has been entered, “rSt All donE” appears

and the screen resumes auto-scrolling parameters.

• If you are in Conguration mode and the correct password has been entered, the display

returns to the screen that required a password.

• If an incorrect password has been entered, “PASS ---- FAIL” appears, and:

• The previous screen is redisplayed, if you are in Reset Mode.

• The previous Operating Mode screen is redisplayed, if you are in Conguration Mode.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 93 94

No comments

Delta 100 Series Installation Manual Page 52