Delta 20-140 Instruction Manual download pdf (Page 8)

Fig. 10

Fig. 11

Fig. 12

Fig. 13

VISE

Clamping the workpiece can be accomplished quickly

and easily as follows:

1. Lift half-nut (A) Fig.10, off screw (B).

2. Pull out screw handle (C) Fig.10, far enough to allow

workpiece (D) to be placed in vise opening against rear

vise clamp (E) as shown. NOTE: It is not necessary to

thread screw handle (C) when the half-nut (A) is in the

raised position. The screw handle (C) can be rapidly

pulled out or pushed in.

3. Push in on screw handle (C) Fig. 11, until front vise

clamp (F) contacts workpiece (D).

4. Flip half-nut (A) Fig. 11, over to engage screw (B)

and tighten screw handle (C) to securely clamp work-

piece (D) in the vise.

ANGLE CUTTING

1. Loosen two screws (G) Fig. 12, and rotate rear vise

clamp (H) to the desired angle. Then tighten the two

screws (G). The front vise clamp (F) pivots on its post

and will automatically align itself with the workpiece.

2. Fig. 13, illustrates a workpiece clamped in the vise

for a typical angle cutting operation.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta 20-140 Instruction Manual Page 8