Delta 36-600 User Manual download pdf (Page 6)

FOR ALL SAWS

(Including Delta Models 34-67-, 34-380 and 36-600)

5. Using the template (G) Figures 8 and 9, check and

adjust front rail (C) at both sides of the saw table as shown,

to make sure rail (C) is level with table surface. THIS

MEASUREMENT IS CRITICAL. IF NECESSARY, AN-

OTHER PATTERN CAN BE MADE USING THE DIMEN-

SION FOUND IN FIG. 10. IMPORTANT: Template (G)

Figs. 8 and 9, must be on the saw table when checking,

not on extension wing.

FOR DELTA TABLE SAWS

(Except Models 34-670, 34-380 and 36-600)

6. When you are certain front rail (C) Figs. 8 and 9, is

level with the table surface, securely tighten front rail

mounting hardware.

FOR ALL OTHER SAWS

(Including Delta Models 34-670, 34-380 and 36-600)

7. When you are certain front rail (C) Figures 8 and 9, is

level with table surface, securely tighten bar clamps (D).

8. Check to make certain there is no interference such as

casting ribs behind front edge of saw table and drill a

minimum of four 1/4” through holes into the saw table

using holes in front rail as a template. Fasten front rail (C)

Fig. 11, to saw table using the four 1/4-20 x 1-1/4” long

flat head screws (H), flat washers, lockwashers and hex

nut supplied. Remove bar clamps after front rail is fas-

tened to saw table.

9. Drill an additional through hole in the extension wing

using one of the holes in the front as a template and fas-

ten front rail to extension wing using a 1/-20 x 1-1/4” long

flat head screw (J) Fig. 11, flat washer, lockwasher and

hex nut supplied.

Fig. 8

Fig. 9

Fig. 10

Fig. 116

USE PATTERN AS SHOWN HERE TO GAUGE DEPTH OF

FRONT RAIL. THIS MEASUREMENT IS CRITICAL.

PATTERN

SAW TABLE

FRONT RAIL

2-3/16”

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

No comments

Delta 36-600 User Manual Page 6