Delta 36-600 User Manual download pdf (Page 7)

FOR DELTA TABLE SAWS

(Except Models 34-670, 34-380 and 36-600)

10. Align the two non-countersunk hole (K) Fig. 12, of rear

rail (L) with the two holes in rear edge of saw table and

fasten rear rail to saw table as follows:

For Delta 10” Tilting Arbor Saws, 10”

Contractor’s Saws and 10” Contractor’s II –

Make certain the edge (M) Fig. 12, of the rail is

below miter gage slots an equal distance as shown

and fasten rear rail (L) to the saw using the two

3/8-24 x 1-1/4” long hex head screws, flat wash-

ers, lockwashers and hex nuts supplied.

IMPORTANT: DO NOT USE TEMPLATE SUPPLIED TO

LEVEL REAR RAIL.

FOR ALL OTHER TABLE SAWS

(Including Delta Models 34-670, 34-380 and 36-600)

11. Clamp rear rail (L) Fig. 12, to back of saw table using

bar clamps, making certain left side of notch (N) in rail is

aligned with right side of saw blade as shown, using straight

edge (B). Also make sure edge (M) of rear rail is below

miter gage slots an equal distance as shown.

IMPORTANT: DO NOT USE TEMPLATE SUPPLIED TO

LEVEL REAR RAIL.

12. Check to make certain there is no interference such as

casting ribs behind the rear edge of saw table and drill a

minimum of two 1/4” through holes through the saw table

using the holes in rear rail as a template. Fasten rear rail to

saw table using two 1/4-20 x 1-1/4” long flat head screws

(H) Fig. 13, flat washers, lockwashers and hex nuts sup-

plied. Drill an additional through hole in the extension wing

using one of the holes in the rear rail as a template and

fasten rear rail to extension wing using a 1/4-20 x 1-1/4”

long flat head screw (J) Fig. 13, flat washer, lockwasher

and hex nut supplied. IMPORTANT: If there is no room in

rear edge of table to drill through holes, it will be necessary

to drill #7 holes in table and tap holes using a 1/4-20 tap.

13. Figure 13 illustrates the bar clamp removed and the

rear rail (L) fastened to rear of the saw table and extension

wing using the hex head screws (H) and (J).

FOR ALL SAWS

14. After fastening the rear rail to the saw table, tilt saw

blade to make certain there is no interference between

the guard, splitter and rear rail. If there is, it will be neces-

sary to enlarge the cutout area (P) Fig. 14, in the rear rail.

Fig. 12

Fig. 13

Fig. 14

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments

Delta 36-600 User Manual Page 7

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-600