Delta 36-R31X Instruction Manual download pdf (Page 14)

Fig. 29 Fig. 30

Fig. 32

13. Holding the clear blade guard, lower the saw blade

and assemble the table insert (E) Fig. 30, into the open-

ing on the saw table.

14. Place a straight edge (B) across the table at both

ends of the table insert as shown in Fig. 31.

THE TABLE INSERT (A) SHOULD

ALWAYS BE LEVEL WITH THE TABLE.

If an adjustment is necessary, turn the adjusting screws

(C), as needed, with the 1/8" allen wrench supplied.

FASTENING MOTOR CORD TO SAW

1. IMPORTANT: Turn the blade tilting handwheel

counterclockwise as far as it will go until the saw blade is

in the 45 degree position.

2. IMPORTANT: Turn the blade raising and lowering

handwheel counterclockwise until the blade is at its

lowest position.

3. Fasten motor cord (A) Fig. 32 to the saw frame cross

member (B), using the cable tie (C) supplied with the saw.

CAUTION: Before tightening the cable tie, make certain

that cord (A) is free of any interference from the motor or

saw blade at all possible positions of the motor.

4. After the cable tie is tightened, cut off excess tail of

cable tie (C) Fig. 32.

Fig. 31

Fig. 33

MOTOR COVER

NOTE: IF YOUR UNISAW HAS AN LVC STARTER

BOX, YOU WILL HAVE TO ATTACH TWO BOTTOM

SPRING CLIPS TO THE MOTOR COVER. IF YOUR

UNISAW HAS A MAGNETIC STARTER BOX, THE

SPRING CLIPS ARE ALREADY ATTACHED TO THE

MOTOR COVER.

1. (FOR LVC MODELS) Attach the two motor cover

clips to the motor cover. Align the hole in the motor cover

clip with the hole in the motor cover. Place a 13/64 flat

washer onto a 10-32x1/2" screw (A), insert screw

through the hole in the motor cover clip and thread screw

(A) into the tapped hole in the motor cover, repeat this

process for the remaining motor cover clip, Fig. 33.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

No comments

Delta 36-R31X Instruction Manual Page 14