Delta 37-360 Instruction Manual download pdf (Page 14)

ADJUSTING FENCE

POSITIVE STOPS

The fence on your jointer is equipped with positive stops at

the most used fence positions of 90 degrees and 45

degrees right and left. To check and adjust the positive

stops, proceed as follows:

1. Position the fence 90 degrees to the table making sure

end of stop screw (A) is against stop (B) as shown in

Fig. 22. Then tighten lock handle (C).

2. Using a square (D) Fig. 23, check to see if the fence is

at 90 degrees to the table as shown.

3. If the fence is not at 90 degrees to the table, loosen

lock handle (C) Fig. 22, and lock nut (E). Turn stop screw

(A) until end of screw (A) contacts stop (B) when fence is

90 degrees to the table and lock handle (C) is tightened.

Fig. 22

Fig. 23

Fig. 24

Fig. 25

4. Tilt the fence inward as far as possible and using a

combination square (F) Fig. 24, check to see if the fence is

tilted inward 45 degrees to the table, as shown. If an

adjustment is necessary, loosen nuts (G) Fig. 25, and

adjust screws (H) until ends of screws (H) contact brackets

(J) when the fence is at 45 degrees to the table.

Always make certain the fence locking

handle (E) is tightened before operating machine.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

No comments

Delta 37-360 Instruction Manual Page 14