Delta 37-360 Instruction Manual download pdf (Page 16)

Fig. 30

OUTFEED TABLE

ADJUSTMENTS

For most jointing operations the outfeed table must be

exactly level with the knives at their highest point of

revolution. To move the outfeed table, loosen lock handle

(A)

Fig. 30, and move the table raising and lowering hand lever

(B) up or down until the table is level with the knives.

It may be necessary to adjust the positive stops. Loosen

the two locknuts (D) and (E) Fig. 31, and the two adjusting

screws (F) and (G) when moving the table up or down.

When the table is exactly level with the knives at the

highest point of revolution, tighten lock handle (A) Fig. 30,

and turn adjusting screw (F) Fig. 31, until it bottoms; then

tighten locknut (D). Screw (G) is also a positive stop for the

lower limit of the outfeed table. We suggest that this stop

also be tightened when the outfeed table is set level with

the knives. This will prevent the outfeed table from

accidently being lowered.

ADJUSTING BELT TENSION

The jointer is shipped with two V-belts assembled and

properly tensioned to the cutterhead and motor pulley. If

it becomes necessary to adjust belt tension, proceed as

follows:

Fig. 31

Fig. 32

Fig. 33

1. DISCONNECT THE MACHINE FROM THE POWER

SOURCE.

2. Pull outward on latch handle (A) Fig. 33, and open

hinged access door (B).

3. Fig. 31, illustrates the V-belts (C), motor pulley (D) and

cutterhead pulley (E). There should be approximately 1/2

inch deflection in the center span of the belts (C) using light

finger pressure. To adjust belt tension refer to STEP 4.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Delta 37-360 Instruction Manual Page 16