Delta ShopMaster SM500 User Manual download pdf (Page 14)

1. Turn the switch “ON” to see if the sanding belt

moves to one side or the other on the sanding drums.

If the belt rides on the center of the sanding drums, it

is tracking properly. Turn the switch “OFF”.

2. If the sanding belt moves toward the disc, turn the

tracking knob (A) Fig. 20 counter-clockwise 1/4 turn.

3. If the sanding belt moves away from the disc, turn the

tracking knob (A) Fig. 20 clockwise 1/4 turn.

4. Check again to see if the belt is tracking properly.

IMPORTANT: When the tool is not in use, the switch

should be locked in the “OFF” position to prevent

unauthorized use. To lock the machine, grasp the switch

toggle (A) and pull it out of the switch (Fig. 19). With the

switch toggle (A) removed, the switch will not operate.

However, should the switch toggle be removed while the

saw is running, the machine can be turned “OFF,” but

cannot be restarted without re-inserting the switch toggle.

LOCKING THE SWITCH IN THE “OFF” POSITION

Fig. 19

TRACKING THE SANDING BELT

Fig. 20

CHANGING THE POSITION OF THE SANDING ARM

You can use the sanding arm (A) in the horizontal position (Fig. 21), the vertical position (Fig. 22), or any angle in

between. Loosen the screw (B), position the arm (A) to the desired angle, and tighten the screw (B).

DISCONNECT MACHINE FROM POWER SOURCE.

Fig. 21

Fig. 22

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

No comments

Delta ShopMaster SM500 User Manual Page 14