Delta DP350 Instruction Manual download pdf (Page 9)

IMPORTANT: Clean the spindle taper (A) Fig. 13 and

the tapered hole in the chuck (B) so that they have no

grease, lacquer. or rust preventive coatings.

NOTE: Household oven cleaner can effectively remove

any substance from the spindle and chuck. Carefully

follow the manufacturer's safety rules.

IMPORTANT: Open the chuck jaws as wide as possible

by turning the chuck sleeve (C) Fig.14.

11. Place the chuck (C) Fig. 14 on the taper of the

spindle and tap it with a rubber hammer (D) or a

block of wood and hammer.

NEVER drive the chuck on the spindle

with a metal hammer.

7. Thread the clamp handle stud (M) Fig. 9 in the hole in the rear of the table bracket.

8. Place the drill press head (N) Fig. 10 on the column as far as it will go.

9. Align the head (A) Fig. 11 with the table (B) and the

base (C). Tighten the two head-locking screws (O)

Fig. 10 with the supplied hex wrench.

10. Thread the three handles (P) Fig. 12 in the three tapped holes located in the pinion shaft.

Fig. 9

Fig. 10

Fig. 12

Fig. 11

Fig. 13

Fig. 14

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

No comments

Delta DP350 Instruction Manual Page 9