Delta 36-714 User Manual download pdf (Page 10)

SETTING UP YOUR SAW

The 36-714 comes with a mobile base which can be used

by attaching the mobile base pedal as shown below. If

desired, the saw can also be bolted to the floor.

ATTACHING THE MOBILE BASE PEDAL

RISK OF PERSONAL INJURY. Two

people are needed to turn the saw over on its side.

Carefully turn the saw over on its side to gain access

to the three holes in the saw base used to attach the

mobile base pedal.

Place an M8 Flat Washer (I) Fig. 3 onto an M8x25mm

Hex Head Bolt (H) and insert through one of three

holes (A) in the mobile base pedal and through the

corresponding hole (B) of the saw base. Then, place an

M8 Flat Washer(J), an M8 Lock Washer (K) and an M8

Nut (L) on the bolt and tighten securely. Repeat this for

the other two holes and stand the saw back up again.

The mobile base pedal has two settings. It can lower

the saw onto its leveling feet for stability, or it can lift the

saw up on its wheel for mobility. The leveling feet include

adjustable locknuts for raising and lowering each foot

separately. Be sure the saw is level and will not move

during operation

Do not opoerate saw with mobile base

pedal in the down position.

BOLTING THE SAW TO FLOOR

RISK OF PERSONAL INJURY. Two

people are needed to turn the saw over on its side.

To bolt the saw to a permanent location, do not add the

mobile base pedal included with the saw. (To add the

pedal, see "ATTACHING THE MOBILE BASE PEDAL").

First, you will need to carefully turn the saw over on its

side and remove the two leveling feet and the attached

locknuts, both shown at (F) Fig. 4. Also remove two

wheels (G) by unscrewing the 5/16" Carriage Head Bolts

and 5/16" locknuts that attach them to the base.

Then, remove the nine screws which secure the dust

chute inside the saw cabinet, six of which are shown at

cover by loosening all six screws (D).

Find the holes (E) Fig. 6 in the bottom of the saw and

mark their position on the floor where you want to place

the saw. Be sure saw is on level surface. Drill pilot holes

in these spots and attach to floor using appropriate

hardware. Reassemble the dust chute and side panel.

Fig. 5

Fig. 6

Fig. 4

Fig. 3

I H

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 32 33

Comments to this Manuals

No comments

Delta 36-714 User Manual Page 10

Comments to this Manuals

Related products and manuals for Power saws Delta 36-714