Delta 36-714 User Manual download pdf (Page 16)

SAW BLADE

Disconnect machine from power source.

1. Raise the saw blade arbor to its maximum height.

Assemble the saw blade (C) Fig. 23 to the saw

arbor making sure the teeth of the blade point down

towards the front of the table, as shown in Fig. 23.

Assemble the flange (D) and arbor nut (E) to the saw

arbor and tighten arbor nut (E) as far as possible by

hand, being sure that the saw blade is against the

inner blade flange.

2. Place the open end wrench (F) Fig. 23 on the flats

on the saw arbor to keep the arbor from turning and

tighten arbor nut (E) using the remaining wrench (G)

Fig. 24, by turning the nut counterclockwise.

ALIGNING SPLITTER WITH BLADE

Disconnect machine from power source.

Use a straight edge to check to see if the saw blade (B)

is aligned with the rear of the splitter (G) in Figs. 24 and

25. If alignment is necessary, loosen the screws (A) Fig.

25A which hold the splitter bracket to the rear trunnion.

Align splitter (G) Fig. 25 with the saw blade, and tighten

two bolts (A) Fig. 25A.

Fig. 23

Fig. 24

Fig. 25

Fig. 25A

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 32 33

No comments

Delta 36-714 User Manual Page 16